Gear motor

Gripper motor - used in Wurlitzers after about serial number 32000000 or have had the upgrade kit installed. You need to add the supplied 150 ohm resistor across the rear terminals and secure to the motor plate 44305 with the provided washer and machine screws.

Replaces motor 86449 with addition of 44290 gear & 13123 needle screw.

Note that if you have the earlier brass/bronze finish mounting plate the motor mounting holes (only 2 or three) may not line up with this new motor - you need the newer 44305 updated mounting plate.

Please check the diameter of the output shaft of your existing motor. If it is NOT 6.00mm then you need the 44290 gear as well - see options below to add to the order.